Loading
FVDM

Nano racer mount for Tinyhawk Freestyle

by FVDM Aug 23, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

I'm printing this for a friend. Are there any recommendations regarding orientation on the print bed? Is flat ok? Or does it have to be standing upright (as in the STL) because of whatever forces will be applied during use?

Flat works ok with a PLA print. I did a lot of bad crashes, like front collisions on walls etc... and only broke one. I print them with only 30% infill.

I am assuming this slides over the standoffs right? It doesn't replace the standoffs?

Nevermine it does look like this is a replacement for the standoff

Yes indeed it is a replacement. Works pretty good once you have re-drilled the holes with a 1.6mm drill for the screws to go in. I will try to upload a revision with the correct holes in it when I find the time.

Printed it and it works great. I modified the file a little to enlarge the holes on the top and bottom so the screws will thead without the need for drilling.

Nice make. Could you please share the adapted version that will allow us to not drill the screws out?

EDIT: Never mind. Found it! Thanks both FVDM and DougTSG!

Comments deleted.