Pokemon 134 Vaporeon Dual extrusion Low Polygon
Prints in one piece without supports. alot small extrusions between large travel moves so it may test your retraction/travel moves configuration. Included a single extruder version.
This time i included the neck frill(wiki says its a feeler, who knew?) as a seperate model, because if you are capable of adding a pause command at certain layers in your slicer or manual(which i don't recommend), then the 2nd color can be changed to a third color and back. but you could also skip that and print it in either color, all 3 options looked good but personally the best is White, then The dark blue, then the body blue.
I Like to print BIG so the IRL picture is 20cm tall. printed with the body model with 3 shells(0.4W 0.2H) and infill, the head is very aggressive and i wanted all the details. 5shells and no infill for the spines model and the neck. And I haven't printed the single color version but it should print the same just without extra walls between the parts