Loading
pedroamz

Case BigTreeTech TFT24-V2 updated

by pedroamz Aug 24, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

I was a bit in a hurry and couldn't wait no longer for a case. So I made a remix which takes care of all changes necessary.
I printed it and it works. One thing you could still improve is the attachment. The actual version covers the hole for the TFT-cable so you have to bend it sideways. I would suggest to put the two attachmentscrewhole a bit closer together and also make the clamo a bit more narrow. That would solve the issue.

My remix: https://www.thingiverse.com/thing:3862575

Case for Bigtreetech 2.4" TFT, Hardware V1.1
by Arminth

Were you able to use both versions of Software with single cable ? Were there any changes needed to Marlinfw ?
I still need horizontal mount to put it on my Anet. Probably will make my own as well. Thanks for remix!

USB-opening is not wide enough for the USB-stick. Add .5mm width.
Displayhole needs to be shifted left by 5mm.

Printed. I had to manually make:

  • hole for reset button - it's around 1cm to the left and bottom
  • display hole - it's larger by 1cm, so left side would not be visible
  • mount leg near usb doesn't seem to fit too well, had to make it a little bit thinner

Can you please also add Horizontal sliding gauge ? It would be awesome ( when i'm not using it, i would slide it to close to my ikea base, when do - i'll pull it). Basically the same connection parts with hinges which is facing left or right instead of down please.

Sadly, the latest version Bigtreetech is shipping is not fitting. Display shifted to the right, Reset-button moved down and left. Gap between USB-Port and wall is too narrow for the "feet" of the backcover to fit in. Would be nice, if you could do a redesign according to new measurements on github: https://github.com/bigtreetech/BIGTREETECH-TFT24-V1.1/tree/master/Hardware

I will change.