The AC-Cable-plug of the battery charger was broken, therefore I soldered the cable directly on the connection pins on the PCB.
The enclosure is not watertight and even not protected against splash water.
Disclaimer: You alone are responsible for the changes on electronics and its equipment/enviorment. Working on PCBs should only be executed by trained persons.
To fixate the base part and cap, you could use the snap-function. Anyway, I suggest to also attach 2x M3 screws for better fixation. The cable needs to be fixed with hot-glue and a cable tie. See picture for reference.
I do not know, whether this enclosure is also suitable for other chargers. I used the enclosure for:
- Article Number: 993002100 // Model: BSA4300200
Support is needed for the Cap.stl part
Inventor has been used, ipt files could be shared