Loading
ArtieH

Raspberry Pi 4B Octoprint Case with Fan

by ArtieH Sep 12, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Comments deleted.

Hi
you have made a good work, but … because there always is a "but" ^^
is there a possibility to have the model "Case_Rear_With_Nuts" without the GPIO hole or may be without the GPIO hole "and" its pre-cut location with dotteds, like that, if a day we need to use it then I should have just to cut the dotteds
thanks a lot.

Should be an easy change. When I get some time I'll implement it.

it's a good news, so I will waiting for to print it, thank

Surprise... Had some free time and knocked this out. Give it a try.
Let me know how it goes.

Thanks.

The impression is perfect, but I'm waiting for the screws, I did not see that I needed the size of M2.5 screws, the order on Ebay has passed, just to wait to receive them...

I just finished assembling mine and I noticed there was not very much bite for the screws to assemble the two halves so mine has a pretty large gap where it would not tighten. Would it be possible to add a indention on the bottom where the fan is located so instead of screwing into plastic that a nut sits in a hole and it is secured that way? I have M2.5x25mm screws and they would work great that way. It would only need to be the depth of a nut.

I redesigned the case rear with pockets for 2.5 mm nuts. The case screws required are M2.5 x 25 mm. I didn't include this file in the "Thing Files" since I have not test printed it. I've attached it if you wish to give it a try.

Thanks. That worked out great. I did have to drill out the holes more to get the screws to reach enough.