Fillament Spool Holder with 608zz and M8 rod.
This should be a easy and fast print! Printed mine
@45mm/s, 10% infill.
50mm ?, 10,5mm highest point.
One is for 39mm spool, the other (marked) is for 30mm spool.
I hope it can be useful for someone. Please comment!
1pcs Threaded Rod M8 150mm (Length optional)
2pcs Threaded Rod M8 130mm (length optional, for use with Rod-M8 angles like the picture)
2pcs 608zz Bearing
2pcs M8 lock nut
2pcs M8 nut
2pcs M8 washer
Print two pcs of this "thing" and two Rod-m8 angles (one mirrored for estetic :) ).
Place bearing into middle of both "holders" and put the rod thru and lock it into place.
I am going to use this on my custom build. Bore a hole in chassi and run the threaded rod thru. Locking it in place with two lock nuts and then the holders with ordinary nuts. So that the spool holder is placed on the back of my chassi.
But for now I am using it on my prusa i3 with m8 rod angles.
UPDATE 20140717: Bowden_M5 Fitting