PAB 3.0

by LaSon_by_NCIS Sep 13, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

Could you please make an open back shell for this gun (just cut the sides). would be nice to have a version with the piston and spring visible. Great model anyway. Good work :)

Hi, you can use the PAB1.0 rear half (grip, sear, trigger, trigger guard, toprail, kiri) if you want the see-thru version. No need to print the shell_vents, which are separate pieces on the PAB1.0 and PAB2.0. Note you'll also need the PAB1.0 or 2.0 hardware if you do so.

quick note , the priming bars should be around 26cm 28cm. I am still sorting out the actual on mine.

Will the curved magazine be made available in the future or is it a personal item?

Still in development, so for now it's a personal item. will definitely share it when I'm confident I can replicate it en masse

I was searching to see if can source the parts here in Australia. All looks good apart from the tube. The only sizes I could find are OD 40 / ID 34 and OD 40/ ID 36

You should be ok woth ID36, just compensate on the o-ring (get a thicker one or wrap a few layers of tape under). ID34 is too small, the piston might not fit or too snug