Lightsaber Hilt Stand
This stand has been specifically designed for the lightsabers built in Savi's Workshop at Galaxy's Edge in Disney. It incorporates the workshop logo as the tall stand to hold the emiter end of your saber and there are many varients so you can display the logo of the type of saber that you built (Protection and Defense, Power and Control, etc...)
You can use this with other hilts it's just designed specifically for their size and weight. In addition to being a hilt stand it is also a display case for your kyber crystals. The crystals can be placed in on the plastic stand they come with.
Kyber Crystal Holder
In addition to being a hilt stand for your custom saber you can also display your collection of Kyber crystals in this stand. The crystals can be placed inside the cut out holes and stood up using their small plastic pieces that they come with. The kyber crystal holders were specifically designed to allow you to install your own LEDs under the crystal creating a lighting effect. Once you wire up the LEDs you can print the Wire Cover and close it all up giving you a fitting display for your scrap metal.
You can use different resolution I found .2mm helps the logo on the front show up better, any less and you end up losing quality in the logos. Also don't forget supports. It's a long print and a few hours in is not the time you want to realize you forgot.