Half height single divider bin/insert for the Dewalt Pro small parts organizer. Also fits the Dewalt 20 compartment Pro Small Parts Organizer available from Home Depot.
This design is remixed from the design shared by Spoon77 Made small enough to fit in the corners, and even with the original dividers in place. Along with the horizontal divider, this design also has 2mm tall feet that will sit in the depressions in the box and keep the bins from moving around inside.
I also adjusted the height of these bins to 25mm which means you can stack them one on top of the other. Making the 10 compartment organizer a potential 40 compartment organizer with 20 of these bins.
When the bins are stacked one on top of another, the parts won't even spill out and get mixed if the box is stored sideways or upside down.
The feet in the design necessitate the use of support material if you want to ensure a good bottom. Good support should easily peel off leaving you with a mesh screen.
If anyone can think of any uses of this, feel free to share. ;)
I was using these Dewalt containers to store drip irrigation fittings and emitters, since I collected quite a few. Their size meant I would only need to print these half height bins with at the most, one divider in the middle.
But I also have a design for a full height bin with feet divided into two compartments. If anyone would like me to share that design or create some new ones, feel free to comment.