Some time ago I did two Pitan (https://www.thingiverse.com/thing:2728600) extruders for my printers. These extruders worked very well, but I wanted know if is possible migrate from a Pitan to a Titan e3d cloned.
So I based my research from this thing https://www.thingiverse.com/thing:1727220
I tried to reuse the most count possible of materials, but nevertheless was necessary buy an aditional bearing to use into the idler.
List of materials:
It is too easy and intuitive to install, just follow the pictures but remember: there are just 2 things you must not forget:
- Add the M3 nut below body
- Adjust the M3x8 screw to hold the body
v1.0.0: 2019 - 09 - 15
Warning: This project is still in progres, I could make works this extruder, but at this moment is a bit difficult to tighten the screws when the top is placed.
Also the turn beetween the gears are not too smoth
I am working in these improves.
v1.0.1: 2019 - 09 - 17
I performed some changes to improve the distance between gears, now the turn is much smooth. I think definitively there is not risk to use the extrusor. Feel free to test it :D
v1.1.0: 2019 - 09 - 21
Uploaded Mirrored versions.
v1.2.0: 2019 - 10 - 1
Added mount to use direct extrusion with Ender 3 (Use mirrored parts for this).
Gray and Red