THIS IS A TEST!
Needed a RPi cam V2 and mount for Artillery X1 sidewinder, So i remixed this.
- Its possible that the vibrations destroyes the picture. - Therefore is this a test
Filament type: PLA
4 Top/Bottom layers
3 Perimeters (only 2 perimeters for Cam mount)
Infill: 15% - (i use "gyorid" in cura)
Bed adhesion: if needed
Support: YES - (I use "tree support" in cura)
- print the cover on the side
- Print cam mount on the bottom
- Print the logo on bagside
- Slow down the speed for better result.
Need any changes? pls comment