A folding coat hanger for easy storage and portability.
Its a great gift idea to show off your 3D printer !!.
Updated with smoother edges in version 1.1 19/02/2016
I printed all the parts in PLA.
- Print the hook with a layer height of 0.1, no support and use a brim of about 2mm, this should give it good adhesion to your print bed and make it nice and round, a quick trim and its ready to snap into place.
- Print the main body without support, I recommend a brim of 10mm as it is quite long and prone to warp without a wide brim.
- Print 2 arms again without support, I used a 5mm brim, no support, gently snap the arms into the main body.
The only part that should be tight is the hook fitting into the main body, don't push too hard, just apply pressure and take your time working it into the hole in the main body, it should snap into place and spin freely when inserted all the way in.