Why buy a brush and a pan to clean your DIY area, when you can print your own! (and create more delightful bits of plastic while doing so...)
This is a set of a brush and a pan, which can be fully 3D printed! Assembly is simple, just print all parts, remove the thin plate from the bristles with scissors etc. and snap everything in place! You can cut the bristles to any length you wish and replace it if needed.
The Bristles should be sliced so, that the extrusion starts at the thin plate and ends on the actual body. This way you have better adhesion. Disabling combing in Cura makes each strand look better, as it retracts before passing over the strands. Set part cooling to high.
Check out my other designs here: https://www.thingiverse.com/Superbeasti/designs
das Filament PLA
The handles and bristles are recommended to print on a raft. The bristles should be printed on a 0.4mm nozzle and 0.2mm layer height.