I had an extra bottom plate and no top plate, and I couldn't find a pod design for the Lumenier QAV 210 Charpu or any of its clones, so I made one in Tinkercad. Very basic design that will require bottom-mounting of the battery. It's designed for a 19x19 camera (or smaller). I use HQ 4.8" props on all of my QAV210 frames because clearance is so tight, so 5" props might hit this thing close to the rear and front screw columns. If you have that issue, feel free to load it up in your favorite editor and add some cutouts/reliefs (or just use those 4.8" props).
I haven't printed it yet, but I plan on printing it in TPU on its side with supports, and possibly with two colors (Gulf Racing livery). I'll try to remember to post a pic after I get it printed.
The smaller piece is an SMA mount that goes between the bottom plate and the pod and is held in place by the two rear screws.
Feide Moore TPU TPU