Added a notch to the customizable pacman ghost on the bottom for inserting a generic submersible led (for example: https://smile.amazon.com/gp/product/B07H2ZTL3P/) to illuminate the ghost.
Can also cut a tea light notch from the Pac Guy model (https://www.thingiverse.com/thing:612888) by Fry Hyde.
This was initially just an upload of some changes I had made a couple of years ago, but there will be a few changes now that I'm dusting this modification off.
update 2019-10-28: uploaded versions with a built in sacrificial support layer under the tea light holder, and updated scad code. This makes it a bit easier to print the first layer in my experience (fewer retractions, lower risk of the small feet underextruding and detaching).
Supports are only needed for tea light notch.
0% infill has the best effect. If using the uploaded stls and no infill, make sure to increase top layers or the very top will have a few gaps. Cura's variable layer height feature works great for this.
Print first layer slow (I do 10mm/s for this on PEI) to avoid problems with the bottom part of the ghost separating from the bed since there are a large number of islands.