Originally I Started with The Cloneout Mini H Quad
But wanted something lower profile with a battery that hung low.
This Quad has 8mm & 10mm spacers and arms to allow more room for your speed controls.
I have also included Motor mounts for 2mm and 3mm screws.
all feedback welcome....
Here is a link to the original project
UPDATE Just test flew with a 2200 battery (Max Size) with no FPV equipment and flew great. nice and balanced ( need to use battery placement to balance out). Also added thicker trainer arms since I am currently not the best pilot :)
Made up some 2mm spacers if you want to raise the deck for some more clearance for speed controls STACK EM' UP!
Print the top deck at 25% fill
arms at 80%
lower deck I'm trying 50% and print with fill for the battery straps and clear out with 1/8 drill bit.
The landing gear I have 50% for now but will be experimenting with it.
the landing gear print on its side with no support.
I have included a short upper deck and a long upper deck for FPV equipment (LongBoard).
12 - M3 x 25mm
4 - M3 x 30mm shortened to 26-27mm so not to protrude.
whatever hardware is required for your motors.