Recently there where some knock-off Rotary-Tools at a local discount and I thought, replacing some of the tool-sortiment for my old Dremel, was long overdue.
Then i figured out that this Blue Box of the "Platin-Edition" was a total mess and I had to search too long when i need the right tool.
So i simply thought about some sort of Display to fit the lower drawer for most of the tools.
They have a little bit spacing to get them in and out easily.
Sides have a small notch to interlock them.
I made 3 diffrent Blocks for 3 diffrent Designations.
Polishing, Grinding and Cutting.
NOTE: Anyone know how i can turn things in the preview? XD
thin walls and a low Infill of even 10% is plausible.
The Holes in the Modell are 3,5mm for most toolheads are 3 to 3,3mm
Depending on your printer quality some holes need to be drilled open when the layer shifted or the inner contours become narrow