Loading
seanauff

Dual 40 mm fan lids for Ender 3/PRO AIO case

by seanauff Nov 1, 2019
Download All Files

Thing Apps Enabled

Please Login to Comment

How did you wire this in and what firmware did you change?
Just getting into all this board/firmware stuff and trying not to mess everything up :)

I didn't make any firmware changes to support this mod and the only wiring change from stock was I used the Z axis endstop cable for the Y axis and vise versa, due to the Z endstop cable not reaching since the driver board is mounter further from the switch. The 4 fans are powered directly from the main PSU, so they come on when that is on. I used 12 V fans, so I used a buck converter to step down the 24 V from the PSU.

Do they fit on a Ender 3 Pro aswell?

I added versions that should fit the Ender 3 Pro. I have no way of testing them though!

I don't think so, at least with the rear most fans installed. The wider Y axis extrusion would make the Y endstop and stepper motor clash with the position of these fans. I can move the fan mounts an additional 10 mm from the center which should make it work with the Ender 3 Pro with no issues.