I always wanted to try some linear rails on a printer and with all the people having issues with the ribbon cables on the SWX1 (I haven't yet) I decided to remix the Bondech BMG Prusa extruder to put on this printer.
This was designed for the use of a E3D V6 with a BL Touch, a 5015 parts cooling fan and a 4010 heatsink fan. Ive also included the back for a volcano block, the fan shroud and fan support are adjustable for use with either the V^ or Volcano back.
There is 2 versions of X ends, one is for the use of type C carriage blocks and one for type H carriage blocks. You will only need one set of motor and Idler X ends that match your blocks.
You will use your stock X Idler bracket and pulley set up.
You will need to print 2 of the belt clips, also I printed 2 of the 12mm alignment helper to assist in aligning the rail to the extrusion.
I will make an assembly guide when I get a chance.
I used a clone BMG for use of the internal parts (Bondtech gears, motor gear, hinge pin, etc
(10) M3 x 30
(2) M3 x 40mm
(3) M3 x 6mm
(1) M3 x 8mm
(38) M3 x 10
(17) M3 x 12
(1) M3 x 14
(1) M3 x 16
(1) M3 x 20mm
(2) M3 x 8 countersunk screws
(4) M3 x 6mm countersunk screws
(2) 550mm MGN12H or C rails
(1) 400mm MGN12H rails
(28) M3 slot nuts
(10) M3 nylock nuts
(6) M3 square nuts
(3) M3 x 4 x 5mm brass knurled insert nut
39mm PTFE tube
(1) MR125-2RS Bearing (5x12x4)
This is a work in progress
11/6/19 " Body Carriage" change, moved the wiring attachment point down 4mm to give the wiring bundle more clearance.