A 1:16-scale Son of Whyachi model. This thing is a bit of a work in progress; the assembly process is not as clean as I would like it to be.
Silver, Red, Black
I recommend printing the tie rods horizontally with support interfaces enabled with 0° overhangs. You can print all three at once on one big raft for bed adhesion.
If you want the detailed vents on the chassis, you may need to enable thin wall extrusion.
I recommend assembling the spinning arm assembly prior to mounting it on the chassis. The process is rather tricky, so practicing assembly prior to adding glue is recommended. Make sure the arms can spin before capping off the bottom.
The wheels are intended to have two flat spots that hold them in place within the chassis, though depending on your print settings they may round out. They may take a few tries to snap in properly.