Custom designed tilt mechanism for bicopter/tricopter.
This is inspired by the design from rcexplorer.se and is direct drive. It was designed for the hexTronik DT750 motor and the Corona DS238 MG Servo with an M2.5x20mm socket head bolt as an axle.
The mechanism is direct drive, zipties to a 3/8" square dowel, and has survived a number of crashes.
The DT750 base slides into the slot and is held in place by a single ziptie
The completed project: https://www.youtube.com/watch?v=KAEG0SY7kyA
3D Solutech PLA
I aligned the print so the part that the motor attaches to stands vertically to maximize the strength of the part that attaches to the spline of the servo.