Spool Holder suitable for PrimaCreator 2,3 KG and 3 KG spools. It can be used with all of our smaller spools as well.
Should fit most spools with a maximum with of 10 cm and up to ~32 cm diameter.
Two 608ZZ bearings are used to ensure that the spool can turn smoothly.
Bearings are available for purchase here: https://www.3dprima.com/a-23770/
We recommend using the 5 cm rod with all of our PrimaCreator spools since the spools will be less prone to start wobbling on the rod.
A 3 cm rod is available for use with spools with smaller centre hole.
PrimaCreator PrimaSelect PLA Matt
Supports are only needed for printing the rods standing up. No support needed for the main part of the spool holder.
We use between 10-15% infill and 2-3 shells on the main part.
For the rods we use ~10% infill and 4-6 shells to keep the end bits from snapping off.
It can probably be printed with less infill and still work just as well.