An Air Deflector for the Bosch 1617EVS Router to reduce dust scatter while using in CNC Router.
NOTE - Be careful if you are using a dust shoe that you're not blocking the air outflow. You could overheat your router and severely damage it.
As long as your 3d printer works right the settings are suggestions. 0.2 mm layer height is about the one thing that matters. Infill isn't terribly important, just don't make it so low that it would break if it hits something.
Screws For Mounting
You'll need a couple of screws to mount it on the base of the router. It's already tapped. I cannot recall if the router already had screws and I just used those, or if I had to scrounge. But either way, they were easy to find.