Adventure Force Liberator (nerf) Blaster Reinforcement Parts for Upgraded Spring Loads
The Liberator Blaster can be upgraded to a heavier spring (k25 fits)
however doing this will cause wear and decrease the blaster lifespan
Since the priming bar is below the spring and plunger rod (off center); during priming heavy spring loads will tend to flex the parts upwards.
mine had a broken priming bar after around 2 months; it cracked and bent upwards.
These Reinforcement pieces will help to prevent this.
-they were able to repair my broken one; so preemptive installation onto a healthy blaster should prevent breakage in the first place.
3d printed parts include:
Priming Bar Inserts: (the bar that connects the pump grip to the plunger rod) ; Epoxy these inserts into the hollow sides of the bar to strengthen it.
MainBrace: this large brace fits into the hollow space above the plunger rod
it braces between the spring stop and catch to relieve primed spring loads on the shell
it also blocks the plunger rod from flexing upwards during priming; which in turn means less bending of the priming bar
-mainbrace will print on a 120*120 MP Select Mini if rotated diagonally, beware of warping/lifting with large prints!