This is a 16 round springless nerf rival magazine. It should only be used with the rival Hera or other blasters with similar chambering mechanisms due to the large force applied by the magazine. It operates using a 1/16” shock cord as the spring element. The maximum length of this magazine has not yet been found so theoretically it could be extended to be much longer. I have included a technical drawing of a dimensioned sectional view so that an extension could easily be modeled if desired. This design was inspired by my observations of adas1223's design "Nerf Rival 16 round magazine"
Orange, White, Black
Only the "Finger" part needs to be printed with supports. I do recommend a 5mm brim on all other parts especially the tall ones. Check the picture for the recommended printing orientation.
- Debur tool (Could be a knife)
- Scissors or nippers
- Small tool to clean out stringing in small long holes (I used a small zip tie pipe cleaners could also work)
- 1/16" shock cord (I got mine here on Amazon)
- Printed parts
- 3" of 1.75mm filament