Casing for self buildt dipol antenna - forms the center part of the antenna to mount a BNC jack and the dipol radials. There are two versions available, one with and one without wall mount.
Casing printed in PLA with 100% squared infill to give it enough stability to hold the radial tubings.
Dipol itself is made out of heavy copper ground wire. The radial tubings are made out of plain 16mm PVC wire tubing usually used for house installation. The end caps are 16mm chair leg protectors.
Everything is glued together with a special glue (Germans: Pattex PLASTIX), that also works fine on PLA. Copper wire and BNC jack installation is additionally hold in place with hot glue - be careful when using PLA: Hot glue tends to be a little bit too warm for PLA! Using too much at a time will damage (melt) the casing!