I've re-scaled the layout 3mf and the single parts should also be scaled to the correct size but if they load wrongly just open the 3mf file and save the individual part. In addition I've uploaded my own chitu-box stl files.
Run the files through the photon file validator to ensure they print well (there may be the odd tiny pixel missed but it will not effect the print)
Having some fun with various new uploads for marine building. Noticed there was a lack of Tech Dudes out there. Sooooo here's my take on a Primaris (roughly) sized generic marine. For my initial design I have uploaded one of the pads with a Scythes of the Emperor logo and a personally made Mechanicum logo. My skills with 3D software are not the best so there a high chance people might achieve better final result with what i'm presenting and as such i'm supplying a complete layout as well as all the broken down parts.
The initial test print was far too big but came out great. The files supplied are scaled down to roughly the correct size but at time of upload this new test print has not finished yet but using calipers it the included files here should match up fine with the normal models.
There is also included a special 50mm round base with rocks and servo skulls to give him a bit more dramatic presence on the table.
Item was printed on my Anycubic photon
Chitubox used for supports
Anycubic Grey resin
Layer Height : 0.05
Bottom layer count : 8
Exposure Time : 10 sec
Bottom Exposure time : 110 sec
Light-off Delay and Bottom Light-off Delay : 1 sec
Bottom Lift Distance and Lifting Distance : 5mm
Bottom Lift Speed and Lifting Speed : 65mm/sec
Retract Speed : 150mm/sec