Just a simple bracket to bring the filament tubes outwards for easier use, and to prevent the filament from slipping off the spool and getting tangled between it and the machine. It also utilizes the stock filament tube holders for easy installation!
DOES NOT FIT THE NEW 2016 MODELS!!!
The first version is with 6.1mm holes, which were perfectly fine for me, after I cleaned the holes with a 6mm drill bit, by turning it in the holes a few times with my fingers.
The V2 file is exactly the same part, except it has 6.2mm holes for those who find the smaller holes too small.
Print it upside up with full supports and a raft for best results. And push the tubes through the holes before you mount the holder on the back of the printer, it's way easier that way!