So many low poly vases. But they always had some off polygons or were not hollowed out. Thus requiring gcode editing (Or a hacksaw). Plus the top got a bit weird with the last polygons not meeting up in a nice point if you used the gcode trick.
So I made one that is perfectly 4 step with 8 polygons on each side. All hollowed out and ready to go. No weird sides, no need for supports, no problem! You can scale this easily right there in Makerware. Uses about 160g ABS if printed as massive (Holds water then) object.
Just print away. It's as ready as they come. Just flip it upright if it is on it's side. Also low resolution looks good. Some people like that printed look. :)