Do you use solder ?

This is a stackable solder spool holder. You can make one for each of your spools of solder, and then stack them up out of the way when you are done with them !

You will need, some 1/8" (3mm) acrylic, about 7.5" by 10" of colored, and about 3.5" x 3.5" or clear. Plus some rod. I use 5/8" wooden dowel cut a little bit shorter then 3 1/4".

If you don't have a laser cutter but would like a solder spool holder, you can get the kit at SpikenzieLabs.com/catalog.
Follow the link to Lasered Items.

For detailed kit building instructions check my YouTube Video:

http://www.youtube.com/watch?v=WsV3_dajtWE

1. Cut out the plastic parts on a laser cutter.
2. Glue the parts together. (Starting with the front clear piece.)
3. Cut the dowel.
4. Fit the solder spool onto the dowel and you are ready to go.