Is your food not expired? Check again!
Cause nobody likes to fined this big guy crawling inside the fridge.
At Halloween, you can get a good prank out of someone who doesn't expect to stare this puppy in the eye.. or better; teeth.
Glue a magnet underneath it's body with the lid, stick it on the in- or outside of the fridge and wait for someone to freak out!
Lids: for 8mm, 10mm, 12mm and 14mm (or smaller) magnets
Video link; https://www.youtube.com/watch?v=OMyWk3RtcMQ
I'm Sander, creator of this 3D Print. And founder of my own 3D Scan & Design service:
Do you love weddings and 3D Printing?
I've opened up a Shapeways shop for 3D printed wedding accessories:
Check out the Wedding 3D shop on Shapeways
A thanks for your interest!
and keep on printing
Print the magnet-lid STL and take the lid that is bigger than the diameter measurements (mm) of your magnet.
The maximum magnet height is 4mm to fit in the magnet-lid.
After printing you can put your magnet in the lid and glue it in the hole of the maggot on the bottom.
If you got questions, please leave a comment.