Solidoodle Fan Mount and Duct for mk3 extruder
by lawsy, published
Liked ByView All
Give a Shout Out
An updated fan mount and duct or the new mk3 jigsaw replacement extruder. This design uses the mk3's easy clip on system as well as a smaller 30mm fan.
Full installation instructions can be found here:
- Print duct and mount.
2.Assemble mount to duct.
Clip into mk3 extruder and tweak angle to direct airflow below the nozzle. Carefully unclip duct and mount at this angle.
Use acetone or glue to permanently bond the mount and the duct.
Insert 30mm fan and mount on Solidoodle mk3 extruder: http://www.thingiverse.com/thing:40711
- Wire up fan and enjoy!
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Solidoodle Fan Mount and Duct for mk3 extruder by lawsy is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving lawsy a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure lawsy would love to see what you've printed. Please document your print and share a Make with the community.