by Zomboe Oct 19, 2010
Download All Files

Thing Apps Enabled

Please Login to Comment

started to print this one today, with awesome results up to 70% of the print. I guess that my printer is slight off on the height adjustment for 2 quadrants, and then some petals broke during the process =/

will align it properly and restart tomorrow.

As requested, I've posted a .rar containing all of my Skeinforge .csv files at the bottom. I am using Axon from Bitsfrombytes, so I think that's where the bfb.csv comes from.

Yes please post your skeinforge settings - you're getting amazing resolution from delicate prints. Thanks!

Thanks! I'll post the skeinforge setting files when I get home, but for now I'll just post this note.

This was printed on a RapMan 3.0 using Ultimachine PLA and 4.x firmware. I basically took the default BfB Axon settings and tweaked them to 0.3mm layers and 32mm/s feed rate. One difference I've noticed between Axon and Skeinforge defaults is that Axon uses 2.0 extrusion width over thickness, fo
r both perimeter and infill. I kept the default Axon settings for the extruder reversing stuff, which does a good job getting rid of the strings.

If you look at the original size images, you can see that the edges are actually pretty rough. There is still a little bit of a blob where the extruder
stops. I replaced the Z axis leadscrews but I am still getting some annoying wobble between the layers.

Usually when I want nicer prints I'll drop down to 0.25mm layers and 16mm/s feed rate. At some point I want to try printing the smaller version of this like that.

Another trick is to print in
translucent material, I've noticed it hides imperfections much better than white ;).

that's a work art.

Could you post your skeinforge .csv file? I'd love to try your setup.

Wow, Thats a really impressive print.

Thank you! I was really surprised it printed as well as it did. Hopefully people will print even better quality copies.