This one has a really nice star shaped base. And a lot of strings! The droopier one reminds me of a spider web. If not for the hole in the base it could be a decent pen/pencil holder.
This Thing was designed with the filament's tendency to droop in mind. Those thin rings in the model should print as single sagging filaments. I designed and printed with 0.3mm layers, but I imagine a little bit larger or smaller should work.
The first print I did was white PLA at 205 degrees. It drooped a little more than I wanted, so I printed it again at 190 degrees. But that one didn't droop at all! I think both look nice. I will have to try again at around 200 degrees though.
I am not sure how much it will droop in ABS, give it a try. Make sure to turn support off!
77.5mm x 73.8mm x 81.6mm tall