A strainer for the kitchen sink.
I wanted something a little different from the ones i was seeing here on thingiverse.
This object was printed WITHOUT perimeters, top or bottom layers.
It's just honeycomb infill !
Printed the strainer in ABS.
0.4mm layers , 25%infill, Zero ( 0 ) top, bottom and perimeters.
Honeycomb infill used.
It is about 80 mm wide at the widest and 70mm wide at the base.
- Real world use has shown that 25% infill catches the coffee grounds and clogs up. I will make another at about 15 - 20% infill to correct this. As always your mileage may vary.