Pop Shield with Brauner Phantom C Mount
by Printbit, published
Use This Project
Give a Shout Out
I went to buy a pop shield and the only ones available were Â£70!
Cue me designing this one.
It's not the most elegant design but it serves its purpose.
Yes, the mount is for a Brauner Phantom C but the mount is separate to the pop shield so have fun designing your own mounts.
The mount and the ring can be printed as normal. You may need to trim the corners / sides of the peg to fit the hole in the mount.
FYI I printed at 0.3mm layer height.
The actual pop shield uses Slic3r's infill to create the mesh.
Set Slic3r to:
Minimum 8 perimeters (for a nice think border)
Infill = 0.2
Solid layers top = 0, bottom = 0
In advanced, if you have anything other than 0 in "Infill" and "First Layer" then make sure these match so the infill lines up. I used 125% in both for my print.
I haven't yet experimented with the different types of infill, they could make for some different visual patterns and possibly different pop stopping abilities.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Pop Shield with Brauner Phantom C Mount by Printbit is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving Printbit a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Printbit would love to see what you've printed. Please document your print and share a Make with the community.