Loading
walter

Customizable Battery Case (magnetic)

by walter Feb 18, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Too bad the customizer has been broken for weeks!

Weeks have turned into months. I'd love to print out cases for my AAA and CR123s, but can't.

Comments deleted.

Could you make one for 18650 batteries?
Thanks

Comments deleted.

I thing hole is 3mm big. So i hope it is for 3mm magnet.

What magent size did you use? any place to buy?

Doesn't make the hles for the magnets. I used 10mm/2mm nothing showed in STL viewer

wow, a lot of good suggestions! Thanks! I added an option to use cube magnets, and the ability to write text on the lid and/or the base, since both were easy to do. Might get the other suggestions into a later update.

Too bad I have cubic magnets :D Any chance this gets customizable? These are 3mm fully cubic magnets.
Also it would be cool to have a loop somewhere on the side so I can put a string there and make sure it does not fall (hence, a magnet could be embedded in the protruding side loop and work for 1xN battery).
And finally, alternate cap (or text as some told) would make it easy to sort which battery pack is used or no.
Very nice print & picture btw :)

Woohoo! Way better than the one I would've made. Keep up the good work.

Nice use of magnets!

Hmm, would it make sense to instead just put magnets in the bottom to hold the batteries in? (placing the batteries nub-down)

Any chance of a customizable one with a slide fit lid rather than magnets?

Customizable Battery Case
by walter