Bender can be made as a pose able model
in one of two ways.
I used rubber bands on mine.
A wire would be another good option.
Finally you can glue it into the pose you want.
Frankly the hands are a bit big, and the plate has a bunch
of extra limb segments (as I expected to experiment a bit)
also the segments are a tad larger than they should be.
Please feel free to modify or "perfect" this.
I have had my fill of Bender for the time being.
Support is recommended and 5% infill would be
a good idea (the test print was 0% and had a few holes
around the leg mounting points. (not too visible but infill
should make the holes less of an issue)