These pumpkins make excellent lanterns with a flickering LED candle or two. They can also be used as vases or bowls to hold candy.
Print with 0 infill, no top and spiralize (AKA Joris) the outside -- if possible.
- Print wit:
- 0% infill
- No top
- Speed: See section below
- Spiralize (AKA Joris) the outside -- if possible.
- Purchase a flickering LED tea light, turn it on and place it inside.
- Enjoy your new pumpkin lantern!
The initial outside angle on pumpkins 2 and 3 is below 45 degrees, so you'll want to play with the speed and temperature for the first 20 layers or so. I printed with PLA at 200C and around 40mm/s.