Spool holder using M8 rod and 608ZZ bearing
by mateddy, published
Use This Project
Give a Shout Out
Filament spool holder for spool with hole diameter 20mm to 80mm
Based on xp7amrkr's http://www.thingiverse.com/thing:467008, adapted to fit 608ZZ bearing (22mm diameter, 7mm height, using M8 threaded rod)
Redrawn using OpenSCAD 2014.11.05
Update: please see http://www.thingiverse.com/thing:1523255 for an improved version
Printed using Kossel Mini, Marlin running on RAMPS 1.4
KISSlicer setting: 0.25mm height, 2 loops, 10% infill, speed 45mm/s (30mm/s at perimeter)
Temperature: 200oC extruder, no heat bed
Assembly require two spool holder, two 608ZZ bearing, two M8 nuts, two M8 washers, and one 8mm threaded rod (about 15cm in length).
See also http://www.thingiverse.com/thing:545898 for fitting the M8 rod on aluminium frame.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingPrint Fulfilment
Order a print of this ThingTools and Utilities
Repair, slice, or enhance this Thing
Spool holder using M8 rod and 608ZZ bearing by mateddy is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
Show Some Love
Say thanks by giving mateddy a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure mateddy would love to see what you've printed. Please document your print and share a Make with the community.