ps4 playstation controller wall mount

by yanez Nov 21, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

When I download the file it downloads as a WinRar ZIP archive file, is there any way to convert it into an STL file?

All of the STL files are packed together into a ZIP archive. This is normal on Thingiverse. Just unpack the zip :)

Will this hold the controller vertically? I want to hang this off the bottom of the table next to my couch. Will the USB port get damaged if you don't unplug the cable before you remove it from the cradle? Could you put a notch where the cable goes through so if you don't unplug it, the cable will just come out with the controller?

You reckon that your design will fit a PS3 controller? Also what printer settings did you use?

I assume it should just by scaling it down a bit how much I couldn't tell you. as far as settings medium .2mm with 25% infill no support needed.