This is an open source project on making the Bedini Battery Energizer Available to everyone. This is a device that uses 1 battery to charge several batteries.Lead acid type, but could possibly Recharge Aluminum air Batteries. Plese contribute and improve on this design. Upload this project to other sites.
-READ INSTRUCTIONS.PDF COMPLETELY BEFORE ASSEMBLY-
Print out This rotor and use it with A common 608 skate bearing, 7mmx 8mm x 22mm. the 22mm hole should fit the 22mm roller skate bearing, you can buy the 608 skate bearing from skate shops or on ebay, etc. The bearing should have an 8mm hole (bore) So an 8mm Hex bolt can act as a shaft. The edges Of the rotor are purposely flat to allow gluing of ceramic block or ring magnets to the edge. The size of the rotor is 150mm So it should be small enough to fit on most
Printers. Be sure the inner hole is 22mm.