Warmers can easily be put in pockets, gloves, and boots, but how do we keep our core nice and toasty?
Just place a small to large sized Hot Hands warmer in the basket, attach a lanyard, and hang it around your neck. Then, adjust the lanyard so the warmer sits inside your coat at just the right spot to keep you warm.
BONUS! Slick graphics on the front make SNOW HEAT a great holiday gift. Give an original - give SNOW HEAT!
The SNOW HEAT sample shown was printed in ABS, but PLA should work fine too. The two files print in about 3 hours total time. Below are the settings I used to get the above print:
.2 Layer height
.35 First layer
Lighter settings might work also.
3mm brim is needed to keep corners from shrinking. Add quarters or washers on top of brim and inside the basket once the base grid is done printing.
The front clips may need to be filed slightly if too tight.