This is a combination of flameblade's hilt and the blade from the Master Sword by davidlikes. I did do some modifications to the mesh on the blade as the tip was not correct.
It it hard to tell in the first picture since I'm holding it at an angle, but the whole sword is about 40" long.
For this file, I combined all of the individual cuts that I made for printing, as I only fixed the blade in the cuts and not in my initial file. If you have any problems, let me know.
Since this sword is so big, I printed it by cutting the blade into 6 pieces, the handle into 2, and the big part of the hilt into 4. Then I used Plastruct plastic weld cement to put it all together and spray painted the whole thing.