Loading
GameScape3D

52mm Goblin Knight Charging on Giant Wolf

by GameScape3D Dec 9, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

hi
could you upload the wolf uncut ?

Will you be releasing the others in the set of 5?

Also, a tip for those printing on FDM printers. The back paws form islands that float in support material. These tend to break off the supports or the supports break off the bed. I'm going to be experimenting with different support settings, but a work around is to pause your print just as the paws begin to be laid down and apply a liberal amount of hot glue around/below the paws.

It seems to me that the two halfs of the wolf are not on the same plane. Cura printed some support material under one of them, but not enough, causing a blobby mess. This may only show up when scaling up to large sizes.

Yes, the wolf prints fine at original size, but scaled up to 3x, an air gap become present. I had to split the pieces in Mesh Mixer and then lay them flat in Cura.