This is an optional cable-actuated shutter assembly for the terraPin 6X9 pinhole camera. This will only work on the 6X9 version of the 'slider' insert. A 3mm nut fits into the front plate to receive the tapered thread of the shutter cable release. This mech requires your cable release to actuate at least 10mm.
Look for additional photos in the near future. If you have questions about this add-on to the terraPin 6x9 please post in comments - thanks!
This work is licensed under the Creative Commons - Attribution - Non-Commercial license. This license applies only to the files and documents available for download from the Thing Files section of this Thing.
All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download This notice constitutes a clarification, not a change, to licensing for this design.
Needed to assemble:
2 - 12mm M3 socket head bolts with nuts
1 - M3 nut for threaded end of remote cable release
Superglue or similar
Sand paper and/or files for fit and finish of parts.
Appropriately-sized rubber band (elastic)
Assembly should be evident from the illustration, but pay special care to fit of the sliding shutter for light-tightness.