Well, I have a lot of batteries but the dispensers/hoppers I've tried did not really fulfil my needs, so I designed my own from scratch but was inspired by jgillick's dispenser (thing 310472)
These 2 dispensers each hold 18 batteries.
The AAA dispenser clicks on top of the AA dispenser. (from version 3 AA clicks on top of an AA disperser and AAA on top of an AAA too)
The batteries can slide out from the side, so it does not matter if one side of the dispenser is blocked by something.
Both can be used as separate dispensers as well
Version 2 is extendable and still stackable.
The extension hold 16 batteries. Print more if you need more and stack them...
Added posibility to stack AA on top of AA and AAA on top of AAA.
Reduced the need to tap the batteries (sometimes) for them to roll down.
If you have many batteries, download and print:
If you have too many batteries, download and print:
batt_disp_AA_v2_extension (one or more)
batt_disp_AAA_v2_extension (one or more)
If you need to stack identical dispensers, go for version 3.
No support needed
0,2 mm layer commended but 0,3 mm gives good results as well.
Better printer adjustments --> Better parts fit