Loading
YamashitaKen

Embossing stamp (f.Labo)

by YamashitaKen Mar 15, 2013
Download All Files

Thing Apps Enabled

Please Login to Comment

Hola no se nada sobre crear, y tengo una impresora 3d y me gusta tu proyecto pero como lo hago para hacerle mi propio logotipo, gracias

Hi, in which program did you modeled this? can you share the files?

How thick should each plate be, less the 0.5mm depth?

0.5~0.8mm is good.

That's how hi the lettering is if I am correct. I was wondering about the two plates that the letters/image goes onto?

Well, I think the plates start out at 3mm and are laser etched 0.5mm on each side. Thus, the total plate thickness would be 5mm plus the thickness of your double sticky tape. Cheers!

Why not to do all the goods on 3d printer? why did you use acrilic?
Is the ABS so bad?

ABS is not so bad. But Laser machine's accuracy is better. Especially in the case of small character.

ABS is not so bad, but Laser machine's accuracy is better. Especially in the case of small character.

Thank you! but is it possible to make this thing with ABS?

It is possible. If you use high performance 3D printer, it is easy. When you use not high performance 3D printer, it needs to adjust

What is the longest your embossing plate could be?

The longest size is 60mm × 30mm.

Are the male and female images on the laser engraved acrylic exactly the same size or does one need to be offset from the other, ie: slightly larger all around by a prescribed amount.and if so how much?

Thank you for your interest. Yes, it needs offset. The female image is lager than male. The offset size is 0.65mm. I make male image only paint no outline and make female image paint and outline(0.65mm). Sincerely.