This is a simple RAMPS 1.4 Mount for a Prusa i3 3D Printer which will stand the board off the frame to allow wires to be routed underneath. It has four wire anchor points (2 at bottom and top) which holds the wires in place.
The 2 Piece Dual 40mm 12V Fan mount keeps the stepper drivers really cool, and is hinged which makes accessing the RAMPS Board a breeze.
Visit our website for our full range of parts at: http://ooznest.co.uk/
Parts needed to complete this mount are:
Printed Parts of the attached STL's
RAMPS 1.4 & Arduino Mega2560
2 x 12V DC 40mm Fans
2 x M3 50mm Bolts
8 x M3 20mm Bolts
1 x M3 25mm Bolts
1 x M3 8mm Bolts
12 x M3 Nyloc Nuts
2 x M3 Form A Washers
Instructions can be found on Page's 22/37/38 of our Prusa i3 Instruction Manual Here:
Both fans can be attached to the D9 Output of the RAMPS 1.4 & Controlled with G-Code M106 SXXX