Minimal Raspberry Pi Case
by Rutter, published
Use This Project
Give a Shout Out
If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.Print Thing Tag
A stripped down basic "case" for Raspberry Pi.
Iâ€™m using this Pi as a development platform, and didnâ€™t want to print a bulky case for it. I couldnâ€™t find anything that fit what I was looking for so I designed this. It allows the Pi to be moved around easily without touching the board and contacts, and raises it off the ground about 6mm.
Print the 2 sides, composite and hdmi, then press onto the corresponding side on your Raspberry Pi. It will be snug and take some pressure get it to snap on, be gentle.
The corners at the end of the internal slots round off a bit during printing, and may need to be cleaned out with an x-acto to get it to fit.
These are very snug on my Pi. Iâ€™m not sure of the tolerances on the boards, but Iâ€™ve attached step files if anyone needs to change the openings slightly.
I printed at 10% infill, 2 shells, and .2mm layer height.
Upgrade this Thing with Thingiverse AppsCustomization
Edit, personalize, or revise this ThingTools and Utilities
Repair, slice, or enhance this Thing
Minimal Raspberry Pi Case by Rutter is licensed under the Creative Commons - Attribution - Non-Commercial license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- Remixing or Changing this Thing is allowed.
- Commercial use is not allowed.
Show Some Love
Say thanks by giving Rutter a tip and help them continue to share amazing Things with the Thingiverse community.Tip Designer
We're sure Rutter would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).